Oil and Gas Industry Injector Skid

Injector Skid: an oil and gas customer had a requirement to inject corrosion inhibitor fluid into their main circulation lines at a predetermined amount every 6 months.

As the dosing quantity was small, and the operating period was so infrequent, an air driven positive displacement pump was chosen to simplify the installation as far as possible.

A plunging-piston pump can discharge at a higher pressure than the compressed air that is used to drive the pump, which in this case meant that 5 barG air was used to generate an injection pressure of just over 13 barG.

The injector skid unit was fully fitted out in 304 and 316 SS to ensure a long service life.

An explosion proof control panel completed the stand alone skid unit.

For further information on skid design & build, and skid fabrication, send us a product enquiry or contact Alan Venner at ESI on Ireland: +353 21 4510900; or UK: +44 1633 877505

Let's Connect!

Get in touch with our dedicated team. We are here to help!